CSAD 402 Control systems Assignment 2 2026 | Technological University Dublin
CSAD 402 Assignment 2
Design the Physical Implementation of a Car Cruise Control System.
1. Introduction
Figure 1 shows a model of a cars cruise control
The following specification for the control system is required:
- Zero steady-state error in response to a unit step reference signal
- 2% Settling time of 3s & 5%
2. Physical Implementation
Your task is to carry out a high-level design for the physical implementation of the control system. Your task is to:
- Outline what type of motor might be used for the cruise control system and why.
- Outline what sensors are needed and why (including the option of an observer if appropriate and feasible).
- Outline what hardware/software would be used to implement the controller (you can use industrial standard equipment or design a prototype).
- Outline how the controller will interface with the sensors and
- Outline the control algorithm (at a high level, with a flowchart would be best, include the actual controller parameters identified above).
You do not have to identify specific items of hardware or software – just outline feasible options and detail what criteria would be important (e.g. what accuracy and response times would you be looking for?). Outline potential solutions for amplifying the controller output. Produce a schematic diagram to explain your solution.
3. Presentation
Prepare a brief presentation on your outline design and record a video of your presentation. This should be not more than 3 minutes long. See the instructions on ‘Assignment 2 Student Instructions for Recording’ for guidance on how to record and upload your presentation. No report is required for this assignment.
Grading
This assignment will contribute to 15% of the assessment for the module. See marking rubric on next page.
| GRADE | |||||||
| Criteria | Weighting | 5 | 4 | 3 | 2 | 1 | 0 |
| Physical Implementation:
Clear demonstration of awareness of: 1. Suitable sensors and factors influencing selection 2. How to interface sensors and actuator with controller 3. Suitable Hardware for implementing the controller, 4. How to implement the controller as a software algorithm. |
70% |
Demonstrates high level of ability and understanding in all criteria |
Demonstrates good level of ability and understanding in all criteria |
Demonstrates fair level of ability and understanding in all criteria |
Demonstrates a basic level of ability and understanding in all criteria |
Insufficient demonstration of ability/understanding |
|
| Presentation
1. Clear slides with suitable images/diagrams to explain concepts. 2. Clear and engaging oral delivery |
30% |
Demonstrates high quality in all criteria |
Demonstrates good quality in all criteria |
Demonstrates fair quality skills in all criteria |
Demonstrates basic quality skills in all criteria |
Insufficient demonstration of skills |
|
New Microsoft PowerPoint Presentation (1).pptx
The post CSAD 402 Control systems Assignment 2 2026 | Technological University Dublin appeared first on Ireland Assignment Helper.